The McDonalds Project.. by n0ftInc

3 minute(s) of a 56 minute read

Started the day cleaning off the case..what a mess!

Then it was header time..

Runner mocked up..

Had a few mivers stop by..here's one of them now!

So, the 3/4 side is tacked and ready for a stronger welder. Originally, I was going to use the J-Pipes, but they weren't the correct size, so I'll be needing to order one more U-Bend and a couple more flanges, and we should be good to go on the 1/2 side.

03.11.10

Pulley machined for the trigger wheel:

Here's a before picture for the record:

Popped into the garage to test some things out and cut some more pipe:

Made a reverse style expansion plug for the distributor hole:

Polishing up the main intake pipe now..

03.12.10

Tried to pull it out, but the manual says we need to be at TDC, so that'll have to wait till it's off the engine stand.

Made some "headway" on the "header" tonight..

Thanks again for the help Darren!

03.14.10

A little earlier, but as of late I was just working on sleep..

Header? Done.

Ordered up some Silicon, and should be here this week..intake fab'n should commence upon arrival.

03.18.10

Went to the junkyard and found these jewels:

..and wrapped up the night by taking out the stock, and putting in some HD Valve Springs:

Tomorrow I'm going to finish up setting up the intake situation and I've got some fresh pushrod tubes to install.

03.19.10

Out with the old:

And in with the new: