Vehicle: Toyota Corolla S
Time/Difficulty: 15-30 Mins/Easy
Tools Needed:
- Phillips-head Screw Driver
- Wrench 3/8 drive
- Socket 10 mm (used to remove the negative battery terminal)
You must be logged in to rate content!
1 minute read
In this video, I am going to show you how to remove the floor console to gain access to the shift cable, handbrake cable, shift lever, 12-volt power source connectors, Supplemental Restraint system (SRS) Electronic Control Unit (ECU), Heater core and some other parts in a 2007 Toyota Corolla S.
This project is necessary when you need to replace the shift cable, change the shift lever bulbs, and any other projects that involve the shift lever.
Comments
Thank you! I hope my video helps somebody in their auto DIY projects.
Posted by SamDIYer on 3/25/20 @ 5:56:44 AM
Good DIY!
Posted by Diggymart on 3/24/20 @ 2:59:43 PM