Z45 Warning! Tons of pics by zmech

2 minute(s) of a 34 minute read

Decided to start making up an engine torque damper. So I dug out the old box spare urethane parts. Hmm, let's see what we have here. Hey this will work. So I am using the urethane that is normally used on the front tension rods for the 84-86 300zx. Found some aluminum pipe that the bushing would just press into and cut it in the correct length. Welded on a smaller aluminum pipe to that pipe. Took off the cross bar mount from the top of the strut tower and made up a two bolt mount up point on it. Just need to measure the smaller tube length and then weld it up to the flat plate to bolt to the tower mount. On to the PICS...





























More to come on this project of course.