You must be logged in to rate content!
3 minute read
88-92 MAZDA MX6/626 SHIFT BOOT/E-Brake INSTALLATION INSTRUCTIONS
1. Remove shift knob by turning counterclockwise.
2. Remove the screw from each side of the front center console piece (2 screws).
3. Remove the two screws from inside the bottom center console tray. Remove the screw from each side of the back center console piece.
4. Pry the small tray out from underneath the e-brake.
5. Remove the 2 screws.
6. Lift up the back center console piece, and then the front center console piece and slide the front piece off.
7. Unscrew shift boot bracket.
8. Remove old shift boot and install new one making sure to line up the wide side of the boot with the wide side on the console.
9. Remove bracket and discard the rubber piece. Install e-brake boot with double stitches on top. You may wish to cut a small notch on the boot for the middle screws on the bracket.
10. Re-install the shift boot bracket and reassemble center console.
11. Carefully snap the tray back into place making sure the boot doesn't pull out from the bracket. You may need to adjust the folds in the leather a bit so it doesn't pull out when you engange or release the brake.
ENJOY YOUR NEW LEATHER BOOTS!
Useful tip
You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.
Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.