You must be logged in to rate content!
2 minute read
MIATA 06+ ROLL HOOP AND DASH INSERT INSTALLATION INSTRUCTIONS
INSTALLING THE ROLL HOOPS
1. The front sections of the roll hoops simply pop off the back side of the bar which is bolted to the actual roll bar.
2. Test-fitting the covers on the roll hoops.
3. To install the covers I sprayed both the roll hoop and inside of the leather with a light coat of 3M adhesive. I let it sit for approximately 30 seconds to tack. Then I positioned the center of the plastic roll hoop on the leather and simply stretched it in place and used plastic clamps to secure it.
4. I let the parts sit for approximately one hour. I then removed the clamps and began making a few snips along the outside and inside edges of the roll hoops to make way for the plastic clips on the roll hoops. Once the snips were made I sprayed the inside of the roll hoops and folded the excess leather inside and allowed to cure for one hour.
5. I then reinstalled by simply pressing the front half into the back half.
