- - Marker
- - Thin scraper with dull edge
- - Scissors
You must be logged in to rate content!
3 minute read
MAZDA3 SUN VISOR COVERS - INSTALLATION INSTRUCTIONS
1. Remove phillip screws from sun visor base.
2. Install cover on sun visor and attach velcro tightly. Make sure the velcro is on the mirror side of the sun visor. Use the marker to trace a rectangle about 3/8” in from the border of the mirror's edge; slide your fingers up against the mirrors edge as a guide. Your marked rectangle should be smaller than the mirror.
3. Remove the cover from the sun visor and cut out the rectangle with the pair of scissors.
4. Slip the cover back on the sun visor, but do not attach the velcro. Start at the bottom corners and slid the material underneath the mirror. Use the thin scraper to push the material flat underneath the mirror.
5. Once the material is flattened out underneath the mirror, attach the velcro tightly to get rid of the wrinkles.
6. Reattach the sun visor to the vehicle by the phillip screws. Now do the other side the same way and you are FINISHED!
ENJOY YOUR NEW VISOR COVERS!
Useful tip
You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.
Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.
