You must be logged in to rate content!
3 minute read
2006 Lexus GS Eyelids
Compliments of http://www.flawlessfitment.com
6-25-2014
So I've been out of the country for a couple of months and honestly haven't done much to the car in awhile. Had a couple of pending projects that I had started but didn't finish so thought I would actually finish one of them.
Our Lexus's come with a fresnal projector lens and well I wasn't very happy with the output so decided to swap in a clear tsx projector lens cause it is actually clear. Well so off to the bake booth/oven it went.
Here is the clear lens in the housing. I did this lens mod on my 2GS retrofit as well and loved the output.
With the headlight out I also wanted to make some eyelids. I couldn't find any eyelids for sale at this time and well hey how hard could it be to make right. lol.. it's a pain!!! Well first step was to mask off the headlight to create a mold per say. I used some silicon spray lube so the resin would not adhere to the tape.
I would've done this in fiberglass too but I didn't have any, but I did have some raw carbon fiber left over from another project. I cut 4 strips, the taped border is so the material doesn't fray.
I used 2 overlay-ed strips on each headlight. Put one strip down, resin it, roll out all the air etc and then lay another strip and do the same.
So that created the form to build from. Next I had to shape it. Trimmed off the excess and taped it up to the headlights to decide on the shape. I used some vinyl tape to help me draw the lines from the factory body line on the fender to the hood. This is what I came up with.
Trimmed off the excess again and this is how everything looked .
Sanded it down, enhanced the lines a little more and a good coat of primer and this is what I was left with.
It's thin, strong, flexible and looks good on the car IMO. Will have some pics up after it is painted and on the car.