GS400 2JZGTE Build in the Mitten State by solaradude

3 minute(s) of a 197 minute read

6-23-2014

It sure doesn't feel like it sometimes, but thanks for the vote of confidence! haha

______________________________________________________________

It took quite a while to remove all of the old head gasket material from the block. I was really nervous about damaging the block or introducing junk into the bottom end, so I had to spend a ton of time with a razor blade cleaning the surface. Hopefully I got it clean enough though and things will seal up nicely.

I installed the ARP head studs, followed by the Apexi head gasket. I learned the hard way that the head needs to be mated to the block before the head studs can be installed or you won't be able to put the washers onto the studs. After removing each stud individually and placing the washer in first, I was able to get everything all buttoned up.

I must have borrowed a 12 point deep 1/2³ socket when I did this with my SR, because I didn't have one to torque the head studs down. I'll have to pick one up this week and take care of that.

I got my valve covers came back from powder coating last week. They didn't turn out as chrome as I had expected, but they look kind of cool. Much better than the dirty and dull condition they were in previously.

The next order of business is to decide on camshafts. The cam gear bolt on the intake side is stuck in the cam, so I need to break that free and replace it regardless of if I go with OEM cams or Tomei Poncams. Everything else for the intake side and timing related should be ready to go once that is sorted out though. I'm thinking about painting the block silver while it's apart as well.