You must be logged in to rate content!
4 minute(s) of a 411 minute read
8-25-2019
More axle work. Got the hubs together and welded the tie rod and one end of the drag link.
8-29-2019
Chipping away at the axle. Got the brakes on. Just need to seal the diff cover, put gear oil in and swap it out with the D30. I need to measure and build the drag link but that will be quick and easy.
9-1-2019
Let's see how this goes over.
I traded the Taco for a new Gladiator. They gave me a trade in value I could not refuse. It was more than I paid for it about a year ago.
9-10-2019
Getting closer.
9-12-2019
Thank you good sir. I'm to the point where I need to cut all the u-bolts and make the draglink. Since I have been wrenching after 8pm, I'll have to wait till the weekend.
9-13-2019
Mocking up the drag link.
9-16-2019
Got the drag link on and tightened up. I think my shocks are too short...have to check.
9-21-2019
Starting her early. Apparently, the Ox locker design changed at some point. I should have googled it before taking it a part. But I like the new design better.
9-23-2019
I started filling the D44 with leftover 75W-90 gear oil but didn’t have enough. I just need to get another bottle then bolt the shocks and then do a poor mans alignment and test drive.
Well maybe. I went to get a new battery for the Jeep at Autozone. It tested bad as I knew it would but I had them check my wife’s car since I was driving it...sure enough, it was bad. Instead of buying (2) batteries that day, I just got one. I’ll get one for the jeep when it’s rolling but may use it for test drives. I charged it up and let it sit in the shop for a few days. I put a voltmeter on it and only 10.60 volts. Must have a bad cell.
9-30-2019
Dang. Well, we'll see how it goes with the Everstart. Jeep runs like a champ right now:
Test ride went well tonight.
10-8-2019
I need to get on it.
Nice build!
Posted by Diggymart on 5/21/20 @ 3:51:26 PM