Louie4's YJ by Louie4

By diyauto
( 2 )

5 minute(s) of a 411 minute read

10-19-2018

So, I decided to replace all of it and only reuse my Flowmaster muffler. A local shop did it all within a few hours and it cost $375 (new cat included).

And I passed the inspection minus my gas cap which the state replaced for free!

Something else I noticed right before the move to Arizona, my clutch was not acting right and fading until I pumped and primed it some. Thus a new clutch master cylinder was purchased.

Last night someone went through my console. Don't think they took anything but they did leave a gift. Really quite odd in my opinion.


11-3-2018

I guess so. I'm not complaining though!

Pics from Table Mesa. Didn't take many because I was drivin'


11-8-2018

Some seat pics...


11-12-2018

Oh yeah. I had a crack on the upper rear shock mount. I stuck my MIG to it and molten metal was put over the crack. I did not say welded for a reason.

Oh yeah...seats.


12-9-2018

I tried to take the Jeep to get food only to get a sluggish battery start and a number of clicks. I threw the charger on it and took it to Autozone a few hours later.

Battery tested good and was at 100%. Anyway, I cleaned the already clean terminals and it worked like a champ.

Maybe it’s the starter? Not really sure. Battery is almost 5 years old.


12-19-2018

Found a draw of 0.39A from the positive lead from the winch. Unhooked it and it has been cranking as of late.


12-31-2018

Here are some pics of the winch power lead issue and fix. I used the old boot from my clutch master...and electrical tape.


3-3-2019

I have updates finally. Went wheeling on a 26 mile trail from Lake Pleasant, AZ to Crown King, AZ. Got 18 miles in and hit a traffic jam on the trail full of rigs and rumors.

Anyway, it was awesome but gave me the next mod...a 5 gal Jerry can. Nearly ran out of fuel and in AZ you can get stuck fast.

That was last weekend. This weekend I washed the mud off the Jeep and went to rotate my tires. Took the front tire off and noticed it moved when I jacked it up...

Now it's new ball joints...and brakes as the pads were worn low.

Pics of the trip.


Comments

Nice build!

Posted by Diggymart on 5/21/20 @ 3:51:26 PM