90 yj frame swap and build up by lovett86

2 minute(s) of a 84 minute read

This is the coil and module. I will be making a small cover to go over the module to keep it from getting wet

2-28-2019

I have it wired up. I'm going to make a small box to cover the module to keep it dry

3-3-2019

Had 20 minutes to spare so I did a little bit of work on the jeep. I managed to get the under hood harness attached to the fire wall. That was it

3-6-2019

I've been searching threw my garage for the last 3 days when ever I have time and I've come to the conclusion that when I purged the garage of junk the last time I must have scrapped my carburetor. I had a few different carbs that were given to me for parts. They were all junk, and im pretty sure I accidentally threw out my carb for the 360. I was looking for it so I could order a re build kit for it. Im now on the hunt for a replacement one.

3-8-2019

Talked to a few guys about some carbs. Might be picking one up this weekend or next week after work. Also tested the home built hei set up and it works and I have spark at the plugs.

I took a video of me spinning the distributor by hand and you can hear and see the spark on the plugs. A couple of the other guys in the shop thought it was pretty cool to watch