You must be logged in to rate content!
1 minute read
Ultra clear, step-by-step guide on how to change out a leaky rear pinion seal on a Jeep Wrangler TJ. The axle is a Dana 44, so it should be the same for all jeep wranglers with a Dana 44 rear end. The process is very similar for a Dana 30 front axle as-well. Save yourself some time and use the right puller device (https://amzn.to/2xcoGfD) instead of a flat head and a hammer. Make sure you use blue loctite on all threads before putting them back. Here is everything I used in the video:
Seal puller - https://amzn.to/2xcoGfD
Spicer pinion seal - https://amzn.to/2Ftl5OX
Reusable bell housing seal (if you had to flush fluid) - https://amzn.to/2N2slHI
1 1/8 socket head - https://amzn.to/2ICa9jZ
Cheap bungee cords - https://amzn.to/2Fs6uDA
Tactical flashlight - https://amzn.to/2IzBNOx
Blue loctite (used on all 5 nuts) https://amzn.to/2RuTKka
Magnaflow 18135 exhaust - https://amzn.to/2WySMcm
Bright LED headlights - https://amzn.to/2HJcj0Y
3 pound mallet - https://amzn.to/2RzfYSi
Mechanics tool set - https://amzn.to/2IDlO2a