Unlimicon Build by redrelyt12

3 minute(s) of a 42 minute read

Just picked up this top from craigslist and ordered the deck cover. :-D

3-29-2013

What do you guys think about something along the lines of this crude drawing I made with Paint? I think it'd give a more standout and unique look.

Edit: Not my Jeep, found it on the forum with the painted hinges.

I was thinking the same bedliner material I used on my grille. 

As seen here:

4-11-2013

I've had the urge for a while to do some more spending. Any ideas? I'd prefer maintenance spending at this point.

I'm thinking a Tom Woods Rear CV Drive Shaft. Anyone know the differences between the two on the quadratec page other than the different lift heights?

http://www.quadratec.com/products/52301_915.htm
http://www.quadratec.com/products/52301_916.htm

Also want to replace the u-joints in my front drive shaft and axles, along with the ball joints that Andy and I replaced for Kate. Spicer parts happen to be the recommendation here, right?
Lastly, some black magic stopping power.

4-18-2013

Finally opened up the bumper and sliders from powder coating!

They look great!

From afar...

Bumper:

Step:

I'll shoot the company an email tonight, see what they're going to do about it. I was so excited to install these this weekend...

In other news... It's going to be a long day on Sunday!

It's too bad that so much of the stuff to install is going on the bumper.. We'll see if I'll have to bring it back up to the powder coating place..

In other news, I still have my component speakers, seat heater, tonneau cover, and bimini top to install!