66 Mustang Coupe by Ls1velle

9 minute(s) of a 31 minute read

Started to fit the rear bumper i picked up for a local resto shop along with a few other missing pieces.

Shaved the bolts and welded in the brackets.

Cut apart the ends to get them to fit nice and tight.

3/28/12

Not much new to post just doing body work, sanding and priming. I did get my new clutch and the flywheel surfaced.

4/27/12

Got back from Carlisle with a few things so I can get back at the mustang.

I got a 5.0 conversion rad, dash pad, door panels, carpet kit, master bolt kit, wiring kit, stainless exhaust, billet steering wheel, shaved door popper kit, Shelby scoop and a few other smalls.

5/4/12

Cut up the 98 GT fan to mount to my new rad. It's a bit big but it's what I've got.

5/5/12

Re-covered the steering wheel.

Before

During

After

5/8/12

Rear bumper before

A few cuts

Back in one piece

And one more cut

6/1/12

Not much new to show, unless you like primer dust on the floor. I was sitting looking at the door yesterday didn't like the corners.

It's not much but those are the little details that will set the car apart from the rest. Hopefully I get my wiring and computer back soon and I can get the engine together and running. Then take it back out finish the body work and mods and get it ready for paint. Can't wait to get this thing done. Then it's on to the Chevelle for a redo. Channeled 4.5 inches (stock frame) and a twin turbo 370ci (850hp).

6/10/12

Started on cleaning up the door jambs, also found a bit of rust at the front of the door.

7/28/12

Here's a few pics of the front end back together. Just getting the gaps nice and tight.

9/22/12

Man it's nice to see color on the car, even if it's just the edges. I'll have to wait til next weekend to get the body painted. So here's todays update, the car is edged and turned out really nice. We had a bit of a mishap with the hood, I had it wired up and was wiping it down with wax and grease remover and the wire snapped and the hood hit the floor. It creased the front edge and cracked some filler and tge primer. I banged it out and painted it anyways. I'll fix the outside this week. Here's a few pics, note the color in the pics is not a good representation of the actual color.

Oh ya this car was built in my 2 car garage with the most basic hand tools and no prior body work experience or training.

10/3/12

After getting the hood on and gaped I got the pinstripe masked off and painted. I masked a 1/4 inch stripe but it will end up being 1/8.

10/7/12

This was my first time ever painting a car. It turned out pretty good for a garage paint job. It's got some dust in it but nothing a sand and polish can't fix.

11/17/12

Mustang got a heart transplant today.