'67 Mustang Coupe by bwkelley76

3 minute(s) of a 78 minute read

LCA/Traction bar install....  

These normally just bolt below the factory leaf spring plates. My plates have been modified for the Maier panhard and the wider spacing for the 3.25" truck axle tubes and U-bolts. So I decided to weld the bars directly to my modified plates. I also welded the front mounts to the subframe connectors AND the frame rails.  



MOCKING UP THE REAR

MOCKING UP THE FRONT

NICE AND STRAIGHT

A LITTLE TOO CLOSE TO THE MAIER PLATE

A LITTLE CLEARANCE FOR GOOD MEASURE

LOTS OF WELDING! ...PASSENGER SIDE ALL DONE

DRIVERS SIDE ALL DONE

Took her for a little test drive and SHE HOOKS! Zero wheel-hop and much better communication in corners on and off throttle.  

 Best $100 I've spent so far.

Here are some paint and body pics...

Suspension and steering arrived early!   ...pics coming soon