1929 Chevrolet International - 4 Door Sedan Project by BearsFan315

2 minute(s) of a 636 minute read

Well started assembling the parts back on the Floor/ Toe Board for my 1929

got this all ready to go back in, had to touch up some paint on the frame rail and clean up the area for the ground cable to connect to the frame rail. once that is all done and dried i will install all the floor wood.

got the wood all stripped down, then applied 3 coats of Helmsman to it. ooh does it look nice, yes i used satin did NOT want the bowling ally shine !!

this is permanent install, well at least I hope. used flat head, slotted screws and countersunk holes for clean install. the switch was installed just high enough to get the key in and turn it and NOT rub the wood or interfere. it is also slightly tucked under the front seat, hopefully out of the way of anyone and everyone feet !!

Touched up the paint on the battery tray and around where i ground off the paint on the frame rail for the ground cable and hardware. i want to make sure i have a GOOD SOLID GROUND !!