You must be logged in to rate content!
2 minute(s) of a 891 minute read
12-30-2017
I tweaked the turbo hotside a bit.. rotated the piping on the flange slightly to bring the turbo inboard and further away from the tire for more inner fender clearance. This ended up swinging the compressor housing and intake elbow closer to the radiator support, so cut 3/8" out of the straight tube part of the turbo hotside.
Before...
After...
Naturally, this now cramped any room I had left for asymmetric charge piping between the intercooler and the throttlebody, so I'll have to do a bendy tapered merge pipe from 3.5" at throttlebody to 2.5" by 4.5" overall width oval on the top of the intercooler.
Wow thanks for sharing!
Posted by Diggymart on 3/3/19 @ 12:40:25 AM