1971 3.0CS Euro Model Restoration by drewbaker

3 minute(s) of a 67 minute read

Hey Guys,

So we now have the CS in the shop getting taken apart. 

The plan is to just spot attack the bits that need work. We will bear metal stripe the roof as it has moisture blisters in the paint work but the rest is pretty good. We will remove any traces of bog and repair/weld anything that needs it. We will then fully sand the whole body, hi-fill and repaint. 

Sasha at Deluxe has removed all the trims numbering and labeling every piece and should go back on with out a hitch. He has also finished straightening the doors and squared up the boot and bonnet so now everything closes perfectly. Sasha believes the drivers side front panel has been welded on at some point. It has a poor weld repair at the front window pillar and front corner above the headlight. The gaps are uneven around the bonnet but by the time the rubbers are put back it shouldn't be that noticeable. I think we will ditch the front driving lights, Alpina front air dam and the rear side panel reflectors. 

The interior seats and piece between the rear seats are now at the trimmers and will be re-upholstered whilst we are doing the body, at the same time we will re-veneer all the wood trims. What color/wood should they be? Is it "European Walnut"?

We will send the dashboard off to the dash doctor for repair should come back as good as new. I've got a new Nardi steering wheel and gear knob and handbrake handle. 

I think we will soda blast one of the rims and see what that looks like, if they come up good we may stick with that. Up for debate and change depending on the look. 

So far the parts I know we need are:

A passenger side rear window motor.

All the badges as they are looking worse for wear.

Little plastic knob closer for the tool kit in the trunk.

We will then re-do all the seals in those wells that attract the rust. I should have a more detaile dlist sometime next week.