You must be logged in to rate content!
2 minute(s) of a 84 minute read
4-2-2020
Been off work the last 2 weeks, been doing stuff around the house. Carb kit came in and I'm back to work on monday. Were going half staff in the whole dealership so we'll see how that goes. Gonna take the wife's carb and kit to work and do it there.
Got a new float with it as well. Gonna try and get the idles tubes for it as well.
4-26-2020
Havent touched the carb yet other than taking a few pics for reference for re assembly. Got alot of stuff re arranged in the garage, picked up a small trailer for doing scrap runs with. Started on the brake lines. Only have the axle lines done. Will have to order some wheel cylinders and flex lines soon.
I collect all the rotors from work. We actually machine alot more then we replace. If not for Corona I'd have 3 times that by now.
Here's the carb. We have 2 more guys coming back to work tomorrow so that will put us at half staff. I worked last week and went in a hand full of times over the last month for essential work while we were closed.
Hopefully il have this car up and running again soon.
8-17-2020
No real updates on the jeep or the camero. Replaced both the axle lines and that was as far as I got with it. Still need to order all the flex lines for it. Carb is apart and I need to order a bushing kit for the throttle shafts in it.
Work was pretty busy rite up until now. Haven't been scrapping as much for extra cash as I'd like too since the virus slowed all that down. Bought a new set of trailer tires and mounted them on the trailer. Figured since I'm using it alot it should have good tires. Have 2 spares for it now too.
Hows everyone else doing out there?