Accord325 Dyno Progress and Build

2 minute(s) of a 88 minute read

I though I would share what is in the works for my build. Paul is starting up work on the following parts and will hopefully be completed before Xmas.

1.) 09' 3.7 MDX Heads - Ported, Rebuilt and Decked to bump Compression.
2.) TLS Exhaust Springs
3.) RL cams
4.) Ported MDX Runners

I will probably get PCD's before installing, then it's Flash Pro.

I will also change the timing belt while in there. Is there anything else I should change while the heads are off (seals, gaskets (beside heads), etc.) ?

12-17-2013

A little tease here. Just came in

Wheels - Rota Torques Hyperblack - 17x9 + 30 offset

Tires - (same) Federal Evo's - 235(run more like 245's)-45
They only have 10k on them so really no point of buying new ones. They were fantastic new but really feel they are loosing traction quick, may be cause my car was out of alignment for a while and I have decent camber wear on two tires. 1st is none existent, I just spin. Almost had a pretty good built (flash, cams,DR's, traction bars, exhaust, headers, 30 or 35 shot) Civic Hatch beat me. Did a 20 roll and he was a car out by 2nd, finally grabbed in 2nd, pulled through 3rd on him, hit fourth for about 2 seconds and had a bumper.. End of race.

12-18-2013

Almost forgot, just got my rims done. Even with 245's they are still stretched just a little. I think they look perfect. Sorry for the half ass garage pics, got really busy and it got dark.