You must be logged in to rate content!
2 minute(s) of a 65 minute read
11-24-2009
Got the K member installed just waiting on Struts/Coil over to finish the front end.
Also hoping to get a mock up engine set in the car so I can determine what intake I am going to use.... I would like to use the edelbrock proflo XT if it will fit under my hood.
12-12-2009
Well finally got off my *** and made a bit of progress....
Skinny kid race cars trans cross member welded in, still going to brace it up a bit more but it is a pretty slick set up with the clevis ends on it.
Test fit a edelbrock proflo XT manifold to see if there was any way I could use it, pictures speak for them selves.... BAD *** intake but not going to work for what I want.
Here is a bit of an insight of whats to come.... Wont be this intake I dont think but you get the idea.
Great build! Enjoyed the videos too.????
Posted by Diggymart on 10/18/19 @ 4:06:01 PM