You must be logged in to rate content!
2 minute read
MUSTANG 2015 ARM Rest INSTALLATION INSTRUCTIONS
15. ARMREST COVER INSTALLATION. Open center armrest completely so the armrest is vertical. Remove the plastic underside of the armrest. This plastic piece is large and is the ceiling of the center armrest cavity when closed. This piece is only held in by clips. Pull firmly away from the top of the armrest to disengage the clips.
16. Remove the four screws using a T20 Torx bit that are located on the underside of the armrest and attached to the hinge.
17. Remove the original leather cover by removing all staples around the perimeter of the armrest.
18. To install the Redline cover, glue or staple the new cover over the center armrest. Be sure to include the factory rubber pad that mounts flush on the top of the armrest.
Re-attach the center armrest to the hinge using the four T20 Torx screws.
Clip the plastic cover back to the underside of the center armrest.
Tip 1. Make sure to leave enough clearance for the handles to move to allow the latch to disengage. Do not block their travel.
Tip 2. If you need to remove the handle assembly you can do so by removing the two T20 Torx screws. There is a small metal tensioner that needs to be re-installed in the center slot upon re-assembly if you do this.
