My 89 MI16

2 minute(s) of a 84 minute read

About time this got in :-) #DSMPeugeotECMlinkProject#

6-16-2014

Euro glass headlights and 2g DSM AWD leather shift knob.

7-14-2014

I decided to use Beilstein CO's for this car,I sent out springs and top hats to powder coater and I'll clean up and paint shocks to have them look new again. I also bolted IM for ECMlink project. This weekend I'll remove dash to install black one out of 91 and that would complete 91 black leather interior swap. Last few and next few weeks will make me a busy boy.

8-6-2014

Update:

I was very busy last few months with MI16 engine swap in my 405 Wagon and just got red Spyder done so I finally made progress on this project.

Last saturday I removed factroy intake,injectors,FP regulator,fuel hoses,cap-rotor,spark plug wires,fuel dampner,ECM and wire harness. On Sunday I bolted modified intake manifold with with EVO 560's,2g DSM fuel rail,1g NT TB and all 2g sensors. 

Today I was working on OBD II connector, Peugeot body side plugs and 2g harness.

Picture bellow is two body side plugs that will give me 12V,Grounds,charge light, oil pressure light, oil level light, charge light, check engine light, starter signal and so on.These wires will connect to 2g harness so at any needed time they can be disconnected for any needed repairs or engine swap.