You must be logged in to rate content!
2 minute read
Gen1 heater control bulbs
Compliments of zirconmr2 @ totalmini.com
2-3-2014
heres how to get at the bulbs in the heater controls
first get the controls out of the car
remove downtubes (might have to remove centre dash trim)
unscrew lower switches
unscrew radio
push heater controls back and the wiggle out of the dash
undo plugs etc
now you have this
pop the black clips with a flat screwdriver, 2 on each side, the front panel will come away
now with the same screwdriver, pop the controls off
now pull the internals out of the white housing
turn over the internals an you can see 2 bulb housings, turn them and they come out
once the bulb housing is out, you can either put a new bulb in the housing, put a led in the housing, or replace the housing and bulb/led in one lump, depends how you purchase them