Project Cliff - The Cherry Red Thirty by stretch tech

2 minute(s) of a 220 minute read

today we finished off the repairs to the boot floor and fitted the rear valance + closures



we then seam sealed the welds



and primed and stone chipped from the heel board back



i then had a poke around the sill with a screw driver...



...how this got through the last MOT i will never know ...







...we were lucky to drive this the two hours home without it falling apart

so we got to work cutting out the last of the rusty metal ( hopefully ) and you will be surprised to know that this side isn't as bad as the other...how ?



new subframe mount repair fitted



2mm thick angle iron to repair and reinforce the base of the companion bin and rear inner sill ( the same as we did to the other side )



then we made a panel to repair the rest of the inner sill ( apart from the front floor pan )



then we gave the new metal and welds a clean up and a coat of etch primer



before we packed away for the night, we gave the door step, jacking point and any other areas of remaining rust a coat of rust reverter

tomorrow we will fit the new front floor panel, fit the outer sill, repair the flitch panel, fit the other scuttle closure and then maybe fit the new scuttle and...well...we'll see what happens

3-2-2012

today we started by fitting the lower rear quarter repair



when i said that this side was in better condition than the other, i was wrong ...........the rear quarter was slightly bowed, the jacking point needed re constructing, the door step needed a patch from the hinge panel to the middle of the door frame, the flitch is rotten from top to bottom on the very edge and there was a split in the base of the bulk head from the transmission tunnel to the O/S sub frame mount...all fixed now though ( apart from the flitch repairs )

front floor pan fitted and jacking point repaired



sill fitted, bulk head split welded shut, door step repaired ( utter nightmare to make a patch for ) and all primed and stone chipped





that's it, the floor is now completely done and solid



now it just needs a coat of paint and then wax oil

tomorrow is our last day of work as my dad goes back to work Monday and we aren't working Sunday...so we need to finish ALL of the body work:

- repair the O/S inner wing
- repair the O/S flitch panel
- patch the pedal box mount
- repair top centre of bulk head/dash rail ( where the rust hole in the scuttle was )
- wire brush the roof guttering to check for rust ( fingers crossed it is just surface )

and anything else other than the front end panels as we want to spend out time getting the alignment right next weekend

i might go down to the unit some time in the week and start flatting down the old paint and paint the underside