1929 Chevrolet International - 4 Door Sedan Project by BearsFan315

3 minute(s) of a 636 minute read

question does this tab:
1- get bent over like it is to hold the lens in, or what does it hold in if bent over
2- should this tab be straight up and down
3- how should this tab be

does this tab mate or insert to anything else (the bucket/reflector assembly)

yeah seems logical that it would go in the slot/groove formed by the reflector and the bucket.

i lay then lens in the trim ring, drop in the gasket, then does not seem like the Headlamp Clamp Ring fits in there, like either the gasket is too thick and not allowing it to go or the trim is not tall enough, but looks the same as factory.

trim ring face down

lens in face down (prism to the inside, raised ring/lip to outside, text legible from front)

close up of glass in trim ring, looking through slot

gasket installed

close up of glass & gasket in trim ring, looking through slot

does the retaining ring go lip down like this

or does retaining ring go lip up like this

hink i may have figured it out....  or at least i hope.

temporarily together till the bulbs come in

is this the correct gap and configuration when fully assembled ??