1929 Chevrolet International - 4 Door Sedan Project by BearsFan315

4 minute(s) of a 636 minute read

installed and secured the wood in the 1929 today

Pictures of the Rubber Mat from TFS

these are the marks people talk about and refer too when they talk about waves, creases, wrinkles in the rubber mats. One Supplier for everyone

Few shots of the Mat installed, I had to order Pedal Rubber, will install those once they arrive

Installed all the new power and ground cables last night.

Frame Rail on the Right, Battery on the Left

These cables are pretty rigid, but will Flex if needed. I plan to FULLY Tighten down the connection on the starter and Disc Switch ONCE the battery is in and Cables Routed and Secured. Need to be able to swivel the lug on the Bolt to get the proper Angle !!  May just toss the battery in and fine tune them to be certain. that way there is no more adjusting and configuring later. Battery will go in and stay in after that. will connect charge cables to the battery connectors for ease of access and use.

been installing my new floor and wood, and got the mat installed so put in the accelerator pedal. thought i would follow up on the anti-rattle spring with some pictures of my install.

small spring from my local hardware store, 1/4 SAE Flat Washer

Not sure if this is 100% correct, but it seems to hold together and fit Nicely. The Return Spring goes around the front bolt/ stud of Exhaust Manifold.