You must be logged in to rate content!
4 minute(s) of a 891 minute read
2-27-2018
Returned the "gold blade" 2009+ LS3 throttlebody to Summit and ordered a "silver blade" 2005-2008 LS2 throttlebody from Rock Auto. Didn't think the size would be that different between the 90mm 4-bolt TB and the old 78mm 3-bolt truck TB. Pretty interesting to compare side-to-side.. I can't help but think that the increase in size will help even just slightly for transient response etc before "teh boosts" kick in....
Also ordered a new waterpump. I wanted a waterpump with a wider pulley, so I could set back the pump body itself (for several reasons I'll disclose later) yet maintain the truck belt alignment.
I originally tried an LS2 water pump with the huge dome-like pulley, but it was a repop ACDelco part number that was absolutely **** in build quality. "Made in China" (I try to not let that affect my evaluation) but the heater hose barbs were pressed in at whacky angles, the pulley wobbled, the block-mounting surfaces weren't parallel.. and the killer was that the thermostat housing part of the body was too bulky/low and interfered with my low-mount alternator bracket.
I also returned the **** ACDelco repro early LS2 waterpump and sought out a legit GM 2005-2008 Corvette LS2 waterpump, which has a short nose pump shaft but a wider width pulley to allow it to be used on the compact Corvette LS2 accessory drive alignment or the mid-compact GTO LS2 accessory alignment.
Here's the 1/2" extra length that the 2005-2008 LS2 waterpump pulley has on the 2009+ LS3 pump.
Naturally when you have a brand new part that you're *pretty sure* will fit, you hack it up. This was to shorten the outlet neck to make the rubber rad hose that I already have fit..
Pretty convenient that I found two pre-cut bits from my box of rad hoses that fit the dimensions perfectly...
And started arranging the 3.5" piping to where the intercooler will be. This pic is kinda funny, shows why I was worried the single middle charge pipe will look like an "elephant trunk" haha..
Wow thanks for sharing!
Posted by Diggymart on 3/3/19 @ 12:40:25 AM