You must be logged in to rate content!
2 minute(s) of a 891 minute read
5-31-2009
Today I took off the cowl support to open it up for more airflow to the larger-than-stock radiator I'm putting in...
I originally thought that this would be the best way to mount the intercooler, so there'd be ample tubing clearance underneath/behind the bumper...
...not so much on the driver side...
Passenger side is the same.
Don't really want to cut up the subframe to get tubing clearance. Plus even if I did that the bends would have to be pretty tight and likely past 90*. So I tried mocking it up this way...
I'll have to make holes in the cowl support then to pass the tubing through... not a big deal. I'm a bit unsure it there's enough room to fit a tight-bend 3" tube or coupler in there though, but I think I can cut anywhere up until the bumper trim support at the 6" mark...
Same deal on passenger side...
I will also have to put slight notches in the top plate of the grill to get it to clear the edges of the intercooler...
Stealth much?...
Wow thanks for sharing!
Posted by Diggymart on 3/3/19 @ 12:40:25 AM