You must be logged in to rate content!
2 minute read
CHEVROLET COBALT/PONTIAC 5 05-07 E-Brake INSTALLATION INSTRUCTIONS
15. Lift the e-brake in its upright position and begin this installation by removing the e-brake bezel (A) as well as the handle cover (B). The bezel is held in place by metal snap fittings. A light tug and the panel will pop up. Push the manual shifter (if applicable) forward to provide enough space to slide the e-brake bezel forward and up. The e-brake handle cover can be removed by pressing the plastic tab on the bottom and sliding the cover off.
16. Cut the e-brake handle cover as shown and discard the front portion as it will not be needed for this installation.
17. Slide the portion of the e-brake handle cover that we just cut onto the e-brake handle as shown.
18. Slide the new e-brake boot onto the e-brake handle as shown. The boot will cover the plastic e-brake handle cover that we installed in the previous step.
19. Re-install the e-brake bezel by sliding it over the handle and boot and secure it by pressing down. Ensure that you hear the metal clips snap into place. That’s it! Test that the e-brake boot doesn’t snag by extending and releasing the e-brake a couple of times. Also ensure that the operation of the e-brake is not restricted. Make necessary adjustments accordingly.
