You must be logged in to rate content!
3 minute read
CHEVROLET COBALT/PONTIAC 5 05-07 ARM REST INSTALLATION INSTRUCTIONS
20. Remove arm rest lid by the 2 Philips screws on the hinge.
21. Remove the 7 philips screws holding the lid to the plastic under cover.
22. Using spray adhesive, I used 3M super 77 adhesive, cover the top of the lid completely with 2 coats.
BE AWARE!!! this stuff is sticky as hell and gets on everything so use a garbage bag or something to cover your work area.
23. Place the padding on top the the deck lid lining it up as you press down. I worked from front to back.
24. Place the cover over the padding lining up the stiching on the sides so its even. NOTE*** let the glue from step 3 dry for appox 30 mins so it doesnt stick to the material and get everywhere.
25. Once you have the cover aligned where you want it, use the 3M super 77 adhesive again and spary the underside of the material and some of the underside lid. Then pull the material over the lip of the lid and press it on the adhesive. It make take a few times till the adhesive becomes tacky enough to hold by itself.
26. Work out all the wrinkles (I had none) and folds in the corners and press down on the material assuring a firm bond between material and lid.
27. Reinstall in reverse order of removal
ENJOY YOUR NEW LEATHER BOOTS!
Useful tip
You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.
Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.