You must be logged in to rate content!
3 minute(s) of a 132 minute read
5-25-2015
Got a little more done today. My hubs should be here by wed too.
I didnt spend too much time getting it perfect, it was just a quick mock up so I could see how the wheels would fit and how much I would have to flare the fenders
yes, it really fits that good! that side even needs to go in about 1/2" too.
I was kinda bored, really not ready to dig into the rear end but what the hell.. its gotta be done at some point
thats where I will need to cut.. 3-5" depending on where the roll center ends up needing to be.
got a little more done, power was out so I was pretty limited. Moved the jack stands and got the car level again
took a little more apart and cleaned up some.
That black line is where it will get cut for the frame. That is if nothing else changes and nothing was over looked, anything is possible at this point
Comments
Will be cool ??
Posted by Diggymart on 1/24/21 @ 2:15:42 PM
Any updates?
Posted by diyauto on 1/11/21 @ 7:46:35 PM
Thanks!
Posted by BerettaLS on 11/13/20 @ 3:47:30 AM
Impressive! Going to leave a lot of unsuspecting people in the dust with this thing
Posted by miatamatt on 11/6/20 @ 7:11:45 PM
Crazy in the best way possible.
Posted by MPower on 10/31/20 @ 3:11:38 AM
This thing is wild! That V8 fits in there nicely. Will be the ultimate sleeper.
Posted by stevegolf on 10/28/20 @ 11:34:27 PM
Any updates ?
Posted by Diggymart on 4/20/23 @ 7:08:14 PM