LS1/t56 swap

By BerettaLS
( 6 )

2 minute(s) of a 132 minute read

11-30-2015

I finally found some time to work on it a bit more. Juggling a few projects again.. Made some decent progress I think.

this is pretty much where its going to sit, I forgot my digital level so im not positive as far as height/control arm angle goes but its with in 1/2" up and down I think. just need to verify it and get it 100% now. beefed up the modified factory subframe a little so I can cut out notches for the control arms to pivot.

finding center. hard to see the yellow center line, but I guessed when I clamped the subframe down, it was less than 1/4" off center! pretty damn good if you ask me!! need to verify my measurements a few times before its set it stone, and get it 100% perfect. front to back is also within 1/8" to 1/4" of being perfect. little bit more tweaking.

fits pretty decent, well better than expected. definitely will need to get cut for clearance but not as much as I was expecting.



Comments

Any updates ?

Posted by Diggymart on 4/20/23 @ 7:08:14 PM

Will be cool ??

Posted by Diggymart on 1/24/21 @ 2:15:42 PM

Any updates?

Posted by diyauto on 1/11/21 @ 7:46:35 PM

Thanks!

Posted by BerettaLS on 11/13/20 @ 3:47:30 AM

Impressive! Going to leave a lot of unsuspecting people in the dust with this thing

Posted by miatamatt on 11/6/20 @ 7:11:45 PM

Crazy in the best way possible.

Posted by MPower on 10/31/20 @ 3:11:38 AM

This thing is wild! That V8 fits in there nicely. Will be the ultimate sleeper.

Posted by stevegolf on 10/28/20 @ 11:34:27 PM