25.3 Outlaw Drag Radial Camaro Build by Eddie Krawiec

By diyauto
( 4 )

6 minute(s) of a 217 minute read

7-15-2012

Well I got in the oil tank. I had it made to hold 5-6 quarts in the tank and between the motor lines etc... it should hold total of 7-8 quarts in the entire system. That should be more then enough for a drag car. I also got it with a pre filter on it to help avoid any extra junk getting in the oil. Here is what it looks like.









I'm waiting on some more photos from DMC on the build side so once I get them I will post them up.

Thanks

I also got my trailer picked this week. This thing is bad ***. I looked at a bunch of trailer builders and to be honest Intech just kept sticking out. So I went and checked out a few different options and came to fact that spending a few bucks more will be more then worth it in the long run.

Well to explain what I mean is the quality of a Intech can not be found in any of the others that I looked. That is what I feel set them a part from everyone else. The seams and joints are spot on and NO SHARP EDGES on anything. The edges all have been filed or sanded so it doesn't feel like you are walking next to a razor blade any place around this thing.

I chose to do a 28" complete aluminum trailer to save on weight. I also opted to spec it out to the way I wanted it built. I went through TCS Trailers or bestpricetrailers.com. They took great care of me and made it easy to build. Intech was good to work with and made it easy to understand the prints. Overall it was a great experience.

Well here are some pictures of it.







Here is inside the box I had made on the tongue. It has the spare mounted to the wall and a air line fitting and electric outlet inside for mounting a compressor in the box. I also will be putting a gas tank to run the generator that will mount to the front wall. This thing allowed me to save a bunch of space inside by using what in most cases is wasted area on a trailer.



I also had a bunch of extra LED's put down the side.





Full aluminum floor on the bottom and door along with outlets every place on this thing. It always seams like trailers never can have enough. It also has a air line in the front and rear inside the trailer and one outside in front of the right side wheels.





The right side is set up to have a roll cart under the bench when loaded and when it is remover it turns into a desk area so you can put you computer and have a place to look at data.





Left side has the Generator box, Locker and upper and lower storage with 2 draws.





One more little trick thing is I have lots of 12v LED's inside the trailer a long with 120v lighting. This is the 12v LED on. Inside each 120v light box is a 12v LED strip and also under each work area is a 12v LED light making sure light will never be a issue.





Well if you are in the market for a trailer and willing to spend a few buck more for something that set's it self a part from the rest I would suggest a Intech. It tows like a dram even with my 1500 pick up and just tracks so nice.




Comments