25.3 Outlaw Drag Radial Camaro Build by Eddie Krawiec

3 minute(s) of a 217 minute read

I'll tell you!!!!! These dam fab guys. First the intake on backwards and now the headers are facing forwards. What does a guy have to do the get stuff right.......









Dennis at DMC is just getting the headers and the hot side of the turbo system buttoned up. He has been busy as can be and doing a great as always with the build. I can't wait to get this thing up and running on the dyno.

5-25-2011

I wanted to get a picture up of the header welded. Joe takes some really killer pictures. Look at the welds on this. Dennis at DMC really tried to show off a little here.





Here are some shots of thedog box area getting cut out so we can fit the intake where it should be. We are going to clean the area up and make it look nice but we just needed to start some place. Also since the area is tight we will most likely be mounting the throttle body under the dash inside the car. It will also help clean up the engine bay.









I hope to have a few more pictures next week. I'll post them when I have them.

Thanks