You must be logged in to rate content!
2 minute(s) of a 140 minute read
1-11-2011
Thank everyone for the comments.
The 1/4 is getting better, still more tweeking, but I have to get the trunk extension in next, then I can finish the 1/4 fit. Next the drivers side.
1-16-2011
Still tweeking the 1/4. I got the trunk extension in place and the 1/4 tweeked to fit over it. The only problem i have now is that the trunk gap is off. It bellies in the middle of the trunk lid. I guess i will have to figure something out later. Maybe some of you will have some ideas. I think i saw someone that had to cut the 1/4 at the trunk lid and made the gap straight. then he welded in a small piece all the way down. Don't remember who did it, but i might try to find the thread. Will post some pics later of the fits and my trunk gap issues. Going to replace rusted metal in drivers side wheel housing.
1-17-2011
Update on pass trk extension install
Here are some pics of the fit of the trunk ext. I was able to bend it to fit and then had to bend the flanges to get a tight fit to tack weld the ext to the 1/4 panel.
I will work on the lower rear panel section next to the 1/4. I might cut away about an 1' or so so i can use a vise clamp to clamp the panels to the brace behing the rear panel. Then i will weld it back in. I will probably then modify the rear panel to close up the gap you see in the pic.
Comments
Coming along really nicely! The color is beautiful!
Posted by MPower on 11/25/20 @ 10:40:33 PM
Cool car!
Posted by Diggymart on 3/30/21 @ 7:46:54 PM