You must be logged in to rate content!
2 minute(s) of a 383 minute read
3-10-2010
Got the driver side floor pan removed tonight. Need to spend some time getting the section in the left-rear area removed still, but that is not a big deal. Will get the edges cleaned up and the spot welds ground down and then time to fit the new floor pan.
3-14-2010
I decided that I just don't have enough to do so I began stripping the interior down to bare metal so I could re-finish it. It's probably overkill, but I figured I might as well go ahead and do it. What's a few more weekends in the grand scheme of things? Just a lot of grunt work, but I think it will be worth it. I'll take off as much as I can with my 4" angle grinder and some 40 grit flap discs and then touch up with the die grinder and sandblasting. Fun, fun, fun!!
3-17-2010
Got off work a little early today, so I spent a few hours stripping more paint off from the interior of the shell. Knocked most areas down to the point of switching over to the die grinder. Should be able to get more done the next few days. I have to go away on business Sat-Tues, so going to lose a weekend, but a break from the Camaro is not a bad thing - will make me come back and hit it harder
This is cool ?
Posted by Diggymart on 1/27/21 @ 4:16:49 PM