Aaron's 76 Type LT Project

By diyauto
( 3 )

2 minute(s) of a 383 minute read

4-27-2010

Added the other patch piece to the inside of the toe board and did some grinding on the welds. I will make it look pretty after I a do a little more grinding. Should turn out fine.

[​IMG]


Did a dry run on fitting the driver side floor pan. Not a bad fit for such minimal adjustment. Should be a really nice fit once I secure it with some screws. Got all the seat track holes drilled in the right spots, so that was a plus.

[​IMG]

The underside of the pan

[​IMG]


5-2-2010

Kind of a ho-hum weekend. Didn't get jack done on Saturday - wife "asked" me to go to a boot camp at her our gym at 2:00 (which I have never done, I lift weights mainly) and it kicked my a$$. Felt like crap the rest of the day.:screwup:

Worked on the toe board today and got the floor pan mostly fitted. Will need a little more tweeking to get the floor pan "perfect" before I begin welding it but should be able to start welding it in Wed night.

For the toe board, I heated the seam with a propane torch and hammered the gap closed as much as I could to make the welding a little easier. My welding skills are improving, but not quite there yet - they're still too globby. I adjusted the way I was holding the gun to give me more control and cleaned the welds more frequently with a wire brush. At least I am not blowing holes through the metal and not getting as much spatter as before.

First round of welding

[​IMG]

After a little grinding

[​IMG]



Comments

This is cool ?

Posted by Diggymart on 1/27/21 @ 4:16:49 PM