71 Cuda Pro-Touring Build by johns cuda shop

By diyauto
( 1 )

2 minute(s) of a 81 minute read

6-27-2011

Not much to report other than I finished the metal work for the engine compartment for now.Finished welding the inner fender supports. I will be getting the Hemi motor and trans ready for the install into the car.







6-28-2011

After changing the oil pan to a rear sump (a center sump won't clear the Alterkation front end) I installed the Flywheel , spec clutch, pressure plate and bellhousing. i need to clearance the belhousing plate slightly to clear one of the bosses on the T56 trans. Then I indexted the bell to the crank than ajusted the CSC cushion ajustment. with everything in spec, I installed the transmission to the engine.











Comments

Cuda!

Posted by Diggymart on 10/12/21 @ 12:38:49 PM