71 Cuda Pro-Touring Build by johns cuda shop

By diyauto
( 1 )

2 minute(s) of a 81 minute read

6-16-2011

After trimming the main roll bar hoop for height, I proceeded to work on the rear supports. I had to cut through the rear seat area for access, then Notched the rear tubes. I sent them locally to be blasted and epoxy primed. When I get them back I will add a removable rear cross brace and possibly side supports and seat belt mounts then weld it together.





6-22-2011

I spent the day drilling out the spot welds on the RH front floor pan and removal ,since this had some major pin holes. I want to keep the pan out as it will make it easier to weld in my supports as I install the motor and trans.





Comments

Cuda!

Posted by Diggymart on 10/12/21 @ 12:38:49 PM