MAP Stage 2 LR 2.4L Build by Blue91lx

3 minute(s) of a 210 minute read

5-13-2012

Well, I sure had another fun night in the garage. My task was to rip the 36K Mivec Motor, T-Case, and fresh Shep Stage 2 Ultimate Ratio trans out of my parts car, mainly because I'm using the Shep in my car!

We ended up having to drop the motor still attached to the trans out of the bottom of the engine bay!

My br0 Stanlsha sitting after we conquered this rigorous task:

Scored some Avid Solid Mounts for my car (I will obviously work my magic polishing them):

Regardless, trans is ready to go in my car, and I'll be doing the cams and such tomorrow. I can't get an 45/64 drill bit anywhere (or an 11/16), so tapping my head for the -10AN lines is on hold until I can find a bit.

Oh, and these are quite yummy:

Sall good brotha! I think your WRX idea will play out quite nicely......if you don't plan on making any power 

Did the only thing left before I time the motor; bolted the cams down.

Hopefully I'll pick up the 11/16" drill bit at Granger tomorrow so I can finish my valve cover project.