Teal Mist 5 Speed Project by food7373

By diyauto
( 4 )

5 minute(s) of a 193 minute read

9-25-2012

9-25-2012


Well no pictures today. Just got done putting on the front. I didn't get home til 4, and had to run and get spring compressors because they didn't come with top hats. I looked for new top hats at some local auto stores, but none had any in stock. I didn't start til about 5, and since the suspension was never taken off before, it was some hard work getting it off. I do have pics of the suspension out of the box though...




The guy told me they only had 1000 miles on the struts, and they haven't been on a car for a little bit. How long does it take for suspension to usually set in? When the front was all said and done, it looks about the stock height still.... Either way, I will do the rears tomorrow which should be much easier, and have some pics then!


Well I grabbed some quick pics...








9-26-2012


Well I finally got the rears in today. Not too bad, just a pain to get the old ones out.. I took more pics for the rear because of request, so here they are!


Well first thing I did was take off the wheel, and jack up the car, which then it looked like this..






Then I opened up the trunk and took the cover out and took off the covers to the top hats and unbolted all 6 nuts.











I then took off the one nut that attaches to the one bolt at the bottom of the strut, and then used a pin to hammer it out and used a bar as well to pry to get it straight...









After that, I put spring compressors on, and tightened them really good....






I then pryed on the top (this part was pain), and then pop! It came out....






Then I got the supra suspension ready to be put on...





And installation is reverse of removal!





So far the rear didn't really set in, but I can tell a small difference. The fronts are different though from this morning. I didn't measure, but I will after a day or two.




The other side is the same thing. So today I finally got a hold of the guys at Tire Rack, and the hub rings are officially on there way. After tomorrow, I will measure the gap and order spacers. After I get both of those, then I will see about CA bushings, steering rack bushings, and sway bar bushings. I really want to get those all done, then re-alignment. I'm pretty excited, I can also definitely tell a difference in handling. I usually drive about an hour and half each day, so I get some good miles in on it daily. So in the mail right now I have some new Lexus emblems coming for the trunk, new HIDs (6k) for headlights and a 6k HID kit for the fogs, and those hub rings. It's getting there! 



Comments

?

Posted by Diggymart on 1/24/20 @ 4:12:48 AM