You must be logged in to rate content!
5 minute(s) of a 104 minute read
5-4-2014
Thanks for all the positive vibe guys!!!
Moving on, the trunk is still a mess and probably at least another 2-3 mounts but parts keep stacking up for other projects.
5-7-2014
test fitting new spoiler that arrived today. not bad =)
5-14-2014
some more progress
finished routing the wires for the Air setup
Made quick disconnects plugs for both compressors
wires on quarter panel routed. power Distribution block and relay mounted here as well.
heading to the other side
Tapped Parking lights and Ignition on the other side, Igntion is to a Fuel Pump Control Module actually, a bit scary to grab it here and possibly short something out and cause vehciles fuse to pop and stall the vehicle but i will fuse small here right after i tap into wire so nothing bad will happen. This way I am not having to run any wires to the Dash besides the Controller.
Dropped the Tank back down
to get it ready to send to powdercoating
Here is the third mounting point
I will Nutsert it
Carpet back in place and now all ready for the tank to be powdercoated and back.
the Third Center Bracket I made
Picked up BeatSonic Navi bypass through Groupbuy also next to it, Power Magic I've been sitting on for a bit for my DVR camera
Up next while I wait for the Powder Coating will be probably to prewire the Amplifier Subwoofer setup since it is all apart anyway and wires are visable so later all I will need to do is fabricate Box and amp mount.