66 Volvo P1800 Custom Build ( Pro-Touring Ls1 V8, Body Mods, and Flush Mount Glass) by Iamtheonlyreal1

2 minute(s) of a 136 minute read

I have been working on my Recessed License Plate... I ordered a Fancy Tag kit from Sachse's Rod Shop in Dallas, and it made it the next day.. It is a very nice gauge steel, so it is actually going to stiffen up my back panel.. I did a couple of modification to it, so I can reduce the size.. I cut an inch out the the center of it, so I can reduce the width, and make it snuggley fit the license plate.. Then I rolled the lower edge up to make a bit of a box unit, but also reduce the over all height..

I think it is in a very close postion to the rendering, and it was really the only position things were going to work out... Also the side of the recessed panel is not welded in at this time, i am doing to wait till media blasting and the final hammering and dollying.. The Rear Panel had some bondo in it and as a bit wavy, that is why you can see a bit of low spots in the pictures...