Dougy's S60R by dougy

3 minute(s) of a 367 minute read

relocated my water/meth delivery nozzle to after Throttle body / directly into intake manifold instead of before...reasoning for that, a couple of days ago TB has failed and i decided to take it apart and found moisture in there. I am not sure how well they are sealed at the shaft nor do I care since I have about 4 TB's ready to replace at anytime, but I am not going to chance TB failure do to internal moisture/short again...also I have rotated the TB so shaft /plate is parallel to the ground as well and no moisture can sit there to seep down the shaft again as well. 

on a brighter note I started tuning with Hilton tuning and it is going really well. 

6-17-2015

Hi Jeff, 

Yep that's correct Jeff it is in the trunk ...I do have a check valve...and I only run straight water.

and the proof...20psi of vaccum.

hi Rudy, hood vents should help...I have air blowing onto my filter through my ram air setup and I was going to make a shroud for my filter setup but i gave up on that since i saw no noticeable difference with my CAI.

my ram air filter setup through frame chassis. 

6-30-2015

almost 2000 miles of pounding since my 2.3l swap. lookin good ... no leaks ... nothing unusual.