You must be logged in to rate content!
2 minute(s) of a 68 minute read
12-10-2013
What i plan on is doing pie cuts and cutting all the pipes to the proper measurement. then just having someone basically weld it together.
Also small update: got my boost controller in
Also got the intake hose for the turbo to intake pipe.
when some more snow melts up here im going to install the turbo again and redo some measurements and hope to find someone to do a decent job on the downpipe.
12-14-2013
Small update:
Im not exactly good at pie cuts but im trying. This is about the right angle for my DP considering the turbo is so much lower than a traditional manifold. So now im talking to a couple people to weld this, then test fit and if i need to add more pie cuts so be it. Ill need to practice more but i dont have tons of pipe. So this will have to do.
12-17-2013
Small update:
figured id take a photo of the intake and how well it fits. Not cutting or aftermarket anything for the distributor. Even the heat shield for the dist is left alone.
12-19-2013
Rough design of the downpipe. I smoothed everything out and sent it with my friend to get tigged up.