You must be logged in to rate content!
2 minute(s) of a 92 minute read
1-14-2010
I decide to relocate the coil packs. I built custom brackets for them and I'm using caprice lt1 plug wires. I am also rerouting some the the engine bay wiring and fixing some leaks I found. I plan on wrapping the hot pipes with DEI Header kit to help battle the heat too.
1-19-2010
Alxxpress said
What did you do for motor mounts? Very freaking cool "street car".
The mounts are f-body but they have metal weld to them to make them solid. It also has the jc kit.
1-25-2010
now for an update:
I started rerouting the wiring in the engine bay to avoid heat and clean up the appearance. Hear are some before and after pictures.
before
after
before
after
The transmission was leaking so I had the guys a Mikes Transmission 505-797-9444 go threw it. They found bad seals, damaged pump gear, and the cause of most of it was the converter wasn't fitting properly. The pilot on the converter was modified and fits like a glove now. The trans looks great. I can't wait to take it for spin. I also go the headers wrapped and put back in along with a transmission scatter shield and drive shaft loop.
