Finally Going Single! Part 2 by cohbra

By diyauto
( 2 )

4 minute(s) of a 168 minute read

4-2-2011

I will not be using the hard lines at all, it is all SS braid on the supply and return from the pump. That is the fuel filter but it is not attached to the firewall. I made a bracket to mount it to the back of the UIM. Here's a pic with it attached. 




4-3-2011


I'm just running pump gas. I do have my harness installed now but I haven't spent any time yet to make sure the harness doesn't rub on the fuel lines. I don't remember seeing anything that really concerned me when I put it in though. Since I'm still out of town on vacation this is the only pic I have that really shows the bracket. 




9-18-2011


I'm trying to get back into this project and finish it up but every time I start, I get a call from work, and I end up having to leave town. I have managed to get a few things done here and there, but nothing major. If all goes as planned, I should be home next week and I will start dedicating a lot more time to getting this thing back on the road. 


In the mean time, I've started thinking about a few things and trying to do as much research as I can while I'm on the road to speed up the process. My biggest concern right now is finding a good base map for the PFC to start with. I expected to find lots of examples on the FC-Datalogit yahoo forum, but I didn't find any (unless I'm looking in the wrong place). Does anyone know where I could find a good map to start with for my setup? 


Power FC/Datalogit

Pineapple Racing Mild Street Port W/Stage 3 Oil Mods.

Greddy T04Z Turbo kit

Synapse 50mm Wastegate

CJ Motorsports Dual Walbro Fuel Pump Assy.

Sakebomb Dual Oil Cooler 25 Row Track Kit

AEM Water/Meth injection

AEM UEGO Wideband A/F Sensor

M-Spec Style Front Mount Intercooler

850CC Primaries

1680CC Secondaries

HKS Twin Power Ignition

GM 3 Bar Map Sensor

Greddy Elbow

Greddy Type RS BOV

Fast Acting IAT Sensor

Dual Pre-Turbo EGTs

Apexi AVC-R Boost Controller



10-5-2011


I've finally managed to get some time home this last week so I've been working hard on trying to accomplish as much as possible before I have to leave again. This week I have:


Installed my wiring for the AVC-R boost controller.

Reworked the engine harness.

Relocated the battery to the passenger side bin.

Installed the AEM water injection in the driver's side bin.

Run new wiring and installed a relay for the two new Walbro fuel pumps in the tank.

Shortened the pipe where my wastegate mounted up (it was sticking down below the bottom of the car).

Fabricated & welded up a brace for the downpipe.

Installed all hoses, belts, & plugs.

Installed new GM 3 bar map sensor.

Repainted & installed windshield wiper arms.

Refinished & rebuilt one of my brake calipers, the other is soon to come.

Began reinstalling some of the interior plastic & door panels.

Began filling all fluids.

Also put power back on the car for the first time - Whew! no smoke!









Comments

Wow nice build with plenty of pics!

Posted by Diggymart on 2/17/20 @ 9:11:59 PM