By stevegolf
1-20-12
Mocking up the new rod end lower control arms...I will be making welded ball joint extenders, to fit in the rod end at the spindle. I should draw it up tomorrow, and get it on the lathe also. Similar to this:
I won't have the same set up, but you get the idea, on where I'm going with the extenders...
You must be logged in to rate content!
2 minute(s) of a 234 minute read
1-9-2021
Mocking up the new rod end lower control arms...I will be making welded ball joint extenders, to fit in the rod end at the spindle. I should draw it up tomorrow, and get it on the lathe also. Similar to this:
I won't have the same set up, but you get the idea, on where I'm going with the extenders...
2-1-12
As far as developments for tonight, finally some welded ball joint extender goodness!
Nice job!
Posted by Diggymart on 3/3/19 @ 12:38:17 AM