You must be logged in to rate content!
2 minute(s) of a 113 minute read
12-11-2014
12-11-2014
I think I'll try to put it in the piece of plate that's under the tail light. I just need to check clearances and length of wires. I can extend my trailer wiring if need be.
I'll have to rethink my reverse light location though.
I also need to add my 110volt outlet back in. Maybe on the other side of the toolbox in the same plate.
12-12-2014
Being able to stand on the ground and pull stuff out of the box is pretty nice.
Played in the headache rack.
No tubing bender as of yet, but it's supposedly on order. Here's a quick tour.
Not quite operational 88ton press break.
Brand new vacuum former. Need to play with this one.
Not I mention all of the other toys like 3d printers in the electronics area.